热处理对挤压态Mn-Cu阻尼合金性能的影响

陆文龙; 姜银方

浏览量 : 0 下载量: 300 CSCD: 5

导出
分享
收藏
专辑

热处理对挤压态Mn-Cu阻尼合金性能的影响
Effects of Heat Treatment on the Damping Properties of the Extruded Mn-Cu Damping Alloy
2002年第6期页码：10-11
纸质出版日期： 2002 ，
DOI：

扫描看全文

[1]陆文龙,,,,,,,,,,姜银方.热处理对挤压态Mn-Cu阻尼合金性能的影响[J].特种铸造及有色合金,2002(06):10-11+3-2.

Lu Wenlong. Effects of Heat Treatment on the Damping Properties of the Extruded Mn-Cu Damping Alloy[J]. Special Casting & Nonferrous Alloys, 2002,(6):10-11.
[1]陆文龙,,,,,,,,,,姜银方.热处理对挤压态Mn-Cu阻尼合金性能的影响[J].特种铸造及有色合金,2002(06):10-11+3-2. DOI：

Lu Wenlong. Effects of Heat Treatment on the Damping Properties of the Extruded Mn-Cu Damping Alloy[J]. Special Casting & Nonferrous Alloys, 2002,(6):10-11. DOI：

摘要

论述了挤压态锰铜阻尼合金的热处理工艺对阻尼性能的影响

并与水冷金属型试样的阻尼性能进行比较。结果表明 :挤压态锰铜合金在热处理工艺为 80 0℃保温 4h固溶处理

水淬后在 40 0℃保温 4h时效处理的条件下

其阻尼性能最好

与水冷金属型试样相比要高出 2 0 %。同时

该合金的阻尼性能随频率变化而变化

在f=2 2 5Hz时出现一个内耗峰

Abstract

The effect of heat treatment on the damping properties of the Mn\|Cu damping alloy in extruding casting

compared with that in the water cooling permanent mold was studied.The results showed that under the condition of the 800 ℃×4 h solution treatment with immediate water quenching and aging at 400 ℃ for 4 h

the optimum damping property of MN\|Cu damping alloy in extruding casting that is higher by 20% than in water cooling permanent mold.Moreover

the damping property of the alloy changes with the frequency.A internal friction peak occurs at frequency 225 Hz.