非真空熔炼下负压铜模吸铸制备块体非晶合金

刘伟; 吴树森; 毛有武; 万里

浏览量 : 0 下载量: 238 CSCD: 0

导出
分享
收藏
专辑

非真空熔炼下负压铜模吸铸制备块体非晶合金
Preparation of Bulky Amorphous Alloy by Suction Casting with Copper Mould under Non-vacuum Melting Conditions
2006年第12期页码：768-769
纸质出版日期： 2006 ，
DOI：

扫描看全文

[1]刘伟,吴树森,毛有武,万里.非真空熔炼下负压铜模吸铸制备块体非晶合金[J].特种铸造及有色合金,2006(12):768-769+748.

Liu Wei, Wu Shusen, Mao Youwu, et al. Preparation of Bulky Amorphous Alloy by Suction Casting with Copper Mould under Non-vacuum Melting Conditions[J]. Special Casting & Nonferrous Alloys, 2006,(12):768-769.
[1]刘伟,吴树森,毛有武,万里.非真空熔炼下负压铜模吸铸制备块体非晶合金[J].特种铸造及有色合金,2006(12):768-769+748. DOI：

Liu Wei, Wu Shusen, Mao Youwu, et al. Preparation of Bulky Amorphous Alloy by Suction Casting with Copper Mould under Non-vacuum Melting Conditions[J]. Special Casting & Nonferrous Alloys, 2006,(12):768-769. DOI：

摘要

研究了非真空熔炼条件下制备块体非晶合金的方法

并设计研制出配套装置。采用非真空条件下高纯流动氩气保护熔炼

再利用外界产生的负压通过导管将玻璃熔体引入紫铜模具内快速冷却制备试样。选用工业纯度的Mg、Cu、Y原材料和Mg65Cu25Y10合金进行试验

成功制备出直径为3mm的完全非晶棒状试样

经检验表明其玻璃转变温度为422K

合金晶化温度为468K。

Abstract

We have developed a method with auxiliary e-quipment to prepare bulky amorphous alloy by suction casting with copper mould under non-vacuum melting conditions

in which high pure argon flow was employed to protect melting of’alloy

and then the glass melt is introduced into a copper mould to rapidly form a sample or a part through a tube based on negative pressure. The Mg65Cu25Y10 amorphous alloy rod with diameters of 3 mm has been prepared successfully with commercial raw materials using the method. Compared with the other preparing methods

the method has the features of low equipment cost

simple process and convenient operation.