锤式破碎机锤头挤压铸造工艺及模具设计

吴夏玲; 邢书明; 姚淑卿; 鲍培玮; 牛建平

挤压铸造 | 浏览量 : 0 下载量: 167 CSCD: 0

导出
分享
收藏
专辑

锤式破碎机锤头挤压铸造工艺及模具设计
Technology and Mold Design of Squeeze Casting for the Hammer Head of Hammer Crusher
2007年第S1期页码：283-285
纸质出版：2007
DOI：
稿件说明：

移动端阅览

[1]吴夏玲,邢书明,姚淑卿,鲍培玮,牛建平.锤式破碎机锤头挤压铸造工艺及模具设计[J].特种铸造及有色合金,2007(S1):283-285. DOI：

Wu Xialing1 Xing Shuming1 Yao Shuqing1 Bao Peiwei1 Niu Jianping2. Technology and Mold Design of Squeeze Casting for the Hammer Head of Hammer Crusher[J]. Special Casting & Nonferrous Alloys, 2007, (S1): 283-285. DOI：

摘要

根据锤式破碎机锤头的结构和使用要求

结合高锰钢材料的特点

进行了锤式破碎机锤头挤压铸造模具设计。液锻成形设备采用专用挤压铸造机

其上挤缸最大挤压力为12500kN。模具总体方案为间接成形

水平分模

1模3件

利用蝶簧与柱簧实现浮动模成形

充分利用锁模缸的能力

采用下缸上行间接顶件。

Abstract

According to the structure and operating requirements of hammer head used in hammer crusher

and the characteristics of high manganese steel

the mold design by Squeeze casting is performed.Specialized former for squeeze casting is used here

and its maximal extrusion force is 12 500 kN.The design scheme is indirect forming

and spring association is used for locking the die

while drip molding is pushed out indirectly by the subjacent fluid cylinder.It is proved in productive practice that:It is feasible to produce hammer by using this set of mold.