液-液原位反应合成TiB<sub>2</sub>/CuCrZr复合材料的研究

翟启明; 张丽华; 王冀恒; 谢春生

复合材料 | 浏览量 : 0 下载量: 141 CSCD: 3

导出
分享
收藏
专辑

液-液原位反应合成TiB₂/CuCrZr复合材料的研究
Preparation of TiB₂/CuCrZr Composites by Liquid-liquid In-situ Synthesis
2007年第4期页码：297-299
纸质出版日期： 2007 ，
DOI：

扫描看全文

[1]翟启明,张丽华,王冀恒,谢春生.液-液原位反应合成TiB_2/CuCrZr复合材料的研究[J].特种铸造及有色合金,2007(04):297-299+244.

Zhai Qiming, Zhang Lihua, Wang Jiheng, et al. Preparation of TiB₂/CuCrZr Composites by Liquid-liquid In-situ Synthesis[J]. Special Casting & Nonferrous Alloys, 2007,(4):297-299.
[1]翟启明,张丽华,王冀恒,谢春生.液-液原位反应合成TiB_2/CuCrZr复合材料的研究[J].特种铸造及有色合金,2007(04):297-299+244. DOI：

Zhai Qiming, Zhang Lihua, Wang Jiheng, et al. Preparation of TiB₂/CuCrZr Composites by Liquid-liquid In-situ Synthesis[J]. Special Casting & Nonferrous Alloys, 2007,(4):297-299. DOI：

摘要

利用液-液原位反应法地制备了TiB2/CuCrZr复合材料

并且研究了TiB2含量对复合材料硬度和电导率的影响。结果表明

TiB2颗粒分布不均匀

呈现团粒状和细长棒状两种形态

在铸态下

复合材料的硬度比常规的铸态CuCrZr合金有较大的提高

复合材料的硬度随着TiB2含量的增加呈先增后减的趋势

TiB2含量为3%时的硬度最佳（HV为206）;电导率随TiB2含量的增加有所下降。

Abstract

TiB2/CuCrZr composites have been successfully prepared by liquid-liquid in-situ synthesis

and the effects of TiB2 content on hardness and electric conductivity of the composites have been examined. The results reveal that the hardness of composites exhibits the trend of initial increase and then decrease with the increase of TiB2 content

observing the maximum hardness

HV 206

with 3% TiB2 content. Electric conductivity of the composites is slightly dropped with the increase of TiB2 content.