Cr、Ni对Cu50Zr42Al8非晶合金摩擦磨损性能的影响

寇生中; 赵文升; 高忙忙; 丁雨田

试验研究 | 浏览量 : 0 下载量: 214 CSCD: 7

导出
分享
收藏
专辑

Cr、Ni对Cu₅₀Zr₄₂Al₈非晶合金摩擦磨损性能的影响
Effects of Cr and Ni on the Friction and Wear Resistance of Cu₅₀Zr₄₂Al₈ Amorphous Alloy
2008年第2期页码：83-86
纸质出版日期： 2008 ，
DOI：

扫描看全文

[1]寇生中,赵文升,高忙忙,丁雨田.Cr、Ni对Cu_(50)Zr_(42)Al_8非晶合金摩擦磨损性能的影响[J].特种铸造及有色合金,2008(02):83-86+77.

Kou Shengzhong1, Zhao Wensheng2, Gao Mangmang2, et al. Effects of Cr and Ni on the Friction and Wear Resistance of Cu₅₀Zr₄₂Al₈ Amorphous Alloy[J]. Special Casting & Nonferrous Alloys, 2008,(2):83-86.
[1]寇生中,赵文升,高忙忙,丁雨田.Cr、Ni对Cu_(50)Zr_(42)Al_8非晶合金摩擦磨损性能的影响[J].特种铸造及有色合金,2008(02):83-86+77. DOI：

Kou Shengzhong1, Zhao Wensheng2, Gao Mangmang2, et al. Effects of Cr and Ni on the Friction and Wear Resistance of Cu₅₀Zr₄₂Al₈ Amorphous Alloy[J]. Special Casting & Nonferrous Alloys, 2008,(2):83-86. DOI：

摘要

利用铜模吸铸法制备了直径为3mm的(Cu

)

Cr1和(Cu

)

Ni1大块非晶合金圆棒。在栓-盘摩擦试验机上对其非晶合金的摩擦磨损性能作了测试。结果表明

添加微量Cr以后

其在低速下的摩擦性能得到了改善

并且提高了非晶合金发生严重磨损的滑动速度;添加微量Ni后

同样改善了非晶合金在较低速度时的摩擦磨损性能

但在高速时的性能改善不明显。

Abstract

The(Cu

)

Cr1 and(Cu

)

Ni1 amorphous alloy rods with 3.0 mm in diameter whose friction and wear properties were tested with the pin-on-disc friction tester were prepared by suction casting with copper mold.The results indicate that the friction behavior at low velocity and the sliding speed of abrasive wear of（Cu50Zr42Al8）99Cr1 amorphous alloy rods are significantly improved by adding Cr element

while the friction behavior at low speed is also obviously improved

however

it has been little improved at high speed by adding Ni.