基于Procast的铝合金筒体差压铸造工艺研究

朱绪祥; 侯立群; 彭银江

计算机应用技术 | 浏览量 : 0 下载量: 358 CSCD: 5

导出
分享
收藏
专辑

基于Procast的铝合金筒体差压铸造工艺研究
Processing Optimization of Counter-pressure Casting Aluminum Alloy Cylinder Based on Procast Software
2011年31卷第2期页码：123-126
纸质出版日期： 2011 ，
DOI：

扫描看全文

[1]朱绪祥,侯立群,彭银江.基于Procast的铝合金筒体差压铸造工艺研究[J].特种铸造及有色合金,2011,31(02):123-126+201.

Zhu Xuxiang, Hou Liqun, Peng Yinjiang. Processing Optimization of Counter-pressure Casting Aluminum Alloy Cylinder Based on Procast Software[J]. Special Casting & Nonferrous Alloys, 2011,31(2):123-126.
[1]朱绪祥,侯立群,彭银江.基于Procast的铝合金筒体差压铸造工艺研究[J].特种铸造及有色合金,2011,31(02):123-126+201. DOI：

Zhu Xuxiang, Hou Liqun, Peng Yinjiang. Processing Optimization of Counter-pressure Casting Aluminum Alloy Cylinder Based on Procast Software[J]. Special Casting & Nonferrous Alloys, 2011,31(2):123-126. DOI：

摘要

运用Procast软件对某铝合金筒体的差压铸造方案进行模拟优化。通过分析充型和凝固过程的温度场

发现在筒体的厚壁部位易出现缩孔、缩松缺陷。经过优化计算

通过提高模具预热温度和厚大部位刷导热涂料

实现了铸件的顺序凝固

提高了成品率

获得了理想铸件。

Abstract

Processing optimization of counter-pressure casting aluminum alloy cylinder was conducted by the Procast software.Shrinkage porosity（hole）can easily occur in the thick-wall position of the cylinder by observing temperature field in filling and solidification process.Sequential solidification can be realized by increasing pre-heating temperature of the mould and spraying thermal-conduction coating at thick-wall position

and qualified rate of the cylinder is raised.